Klarstein Alchemist Handbuch Seite 41

contacts of 3 mm in compliance with current safety codes (the earthing wire must not be
interrupted by the switch). The power supply cord must be positioned so that it does not
reach a temperature in excess of 50 °C than room temperature at any point.
Before actual connection make sure that.
Before actual connection make sure that:
• The fuse and electrical system can withstand the load required by the hob;
• The electrical supply system is equipped with an efficient earth hook-up according
to the norms and regulations prescribed by law;
• The plug or switch are easily accessible.
Important: the wires in the main lead are coloured in accordance with the following
code:
• Green & Yellow - Earth
• Blue- Neutral
• Browc -Live
As the colours of the wires in the main lead may not correspond with the coloured
markings identifying the terminals in your plug, proceed as follows:
• As the colours of the wires in the main lead may not correspond with the coloured
markings identifying the terminals in your plug, proceed as follows: Connect the
Green & Yellow wire to terminal marked "E" or
Yellow.
• Connect the Brown wire to the terminal marked "L" or coloured Red.
• Connect the Blue wire to the terminal marked "N" or coloured Black.
or coloured Green or Green &
EN
41