Mounting And Changing Attachments - Bamix Classic EO120 Vollständige Bedienungsanleitung

Recess
Drive pin
Mount and remove attachment
vertically
Lock in place

Mounting and changing attachments

All attachments feature a recess (figure 1).
The drive shaft stub of the bamix
(figure 2).
Push the attachment as straight as possible onto the stub so
that the drive pin engages in the recess on the attachment. Plea-
Putting on and exchanging the attachments
se make sure that the attachment is exactly parallel to the cutter
guard and properly aligned with the stub (figures 3/4).
Push the attachment as straight as possible on to the st
a way that the drive pin on the stub fits exactly into the s
in the socket of the attachment. The attachment is desig
To remove the attachment, just pull it from the stub. If the
make this process easy. The attachment is removed by s
attachment cannot be easily pulled off, loosen it by placing the
pulling it off from the stub.
bamix in hot dish-washing water and switching the appliance
®
on briefly. Disconnect the power plug from the socket and pull
Careful: For safety's sake, when you exchange the a
off the attachment. If necessary, lever it off with a suitable im-
plement (e.g. screwdriver).
always pull out the plug.
It is possible that, over time, the attachments will not fit as
It can happen that the attachments in time no longer fit
firmly on the stub. In this case, slightly press the spring bla-
on the shaft. In this case simply press the spring blades
des together with a pair of pliers.
together with a pair of pliers.
Before changing the attachment, disconnect the
power plug of the appliance from the socket.
Receptacles
Do not touch rotating attachments.
You can work in any receptacle, even directly in a pan o
stove. Use small receptacles for small amounts and larg
is equipped with a drive pin
®
47