T26_32_DC-AC.book Seite 11 Freitag, 14. März 2008 3:19 15
T26 DC/AC, T32 DC/AC
6
➤ Occasionally clean the device interior and exterior with a damp cloth.
7
Fault
Your cooler does not func-
tion (plug is inserted, LED
(accessory) does not
glow).
Your cooler does not cool
(plug is inserted, LED
(4 1, page 3, acces-
sory) glows).
Your cooler does not heat
(plug is inserted, LED
(4 2, page 3, acces-
sory) glows).
Operation with a
12 V socket
(cigarette lighter):
The ignition is on and the
cooler is not working.
Pull the plug out of the
socket and make the fol-
lowing checks.
Downloaded from
www.Manualslib.com
Cleaning and maintenance
Caution!
Before cleaning the cooler, pull the cable out of the socket or the
cigarette lighter.
Caution!
Do not clean the cooler under running water or in dish water.
Caution!
Do not use abrasive cleaning agents or hard objects during clean-
ing as these can damage the cooler.
Troubleshooting
Possible cause
There is no voltage
flowing from the 12 V
socket (cigarette
lighter) in your vehicle.
No voltage present at
the AC voltage socket.
The inner fan or the
cooling element is
defective.
The inner fan or the
cooling element is
defective.
The cigarette lighter
socket is dirty. This
results in a poor elec-
trical contact.
The fuse of the 12 V
plug has blown.
The vehicle fuse has
blown.
manuals search engine
Cleaning and maintenance
Suggested remedy
The ignition must be switched on in
most vehicles for voltage to flow at the
cigarette lighter.
Try using another plug socket.
This can only be repaired by an author-
ised customer services unit.
This can only be repaired by an author-
ised customer services unit.
If the plug of your cooler becomes very
warm in the cigarette lighter socket,
either the socket must be cleaned or the
plug has not been assembled correctly.
Replace the fuse (5 A) in the 12 V plug
(5 1, page 3).
Replace the vehicle's 12 V socket fuse
(usually 15 A). (Please refer to the oper-
ating manual of your vehicle.)
11