Flex L 1506 VR Originalbetriebsanleitung Seite 21

L 1506 VR, LG 1704 VR
 Screw the clamping nut with flange face
up, onto the spindle.
 Press and hold down the spindle lock.
 Tighten the clamping nut with the stop
key.
 Insert the mains plug into the socket.
 Switch on the power tool (without locking
the button) and leave it running for
approx. 30 seconds. Check for
imbalances and vibrations.
Attaching the Velcro pad
 Pull out the mains plug.
 Remove quick-change guard.
 Press and hold down the spindle lock.
 Using the stop key, loosen the clamping
nut on the spindle in an anti-clockwise
direction and remove.
 Remove clamping flange.
 Screw Velcro pad clockwise onto the
spindle and tighten hand-tight.
Downloaded from www.Manualslib.com manuals search engine
Attaching or changing sandpaper
 Pull out the mains plug.
 Place the sandpaper in the centre of the
Velcro pad and press on.
 Carry out a test run to check that the tool
is clamped in the centre.
Operating instructions
klqb
tÜÉå=íÜÉ=éçïÉê=íççä=áë=ëïáíÅÜÉÇ=çÑÑI=íÜÉ=íççä=
ÅçåíáåìÉë=êìååáåÖ=ÄêáÉÑäóK
Rough-grinding
t^okfkd>
kÉîÉê=ìëÉ=ÅìííáåÖJçÑÑ=ïÜÉÉäë=Ñçê=êçìÖÜJ
ÖêáåÇáåÖK
– Angle of wheel 20–40° for best cutting
performance.
– Move the power tool to and fro, applying
moderate pressure. As a result, the
workpiece will not become too hot and
there will be no discoloration; nor will
there be any grooves.
21