General Information; Basic Safety Notes - Geberit MFP 2 Betriebsanleitung

EN

General information

Note on this document
The original instructions were written in German. All other language versions are translations
of the original instructions.

Basic safety notes

Intended use
The Geberit pressing tool is exclusively used for pressing Geberit
pressing system pipes and pressfittings.
Only use Geberit pressing attachments (pressing jaws, pressing
collars and adapter jaws) that carry the compatibility mark .
The following Geberit pressing system dimensions may be pressed:
• Geberit Mapress pressing system up to dimension 66.7 mm
• Geberit Mepla pressing system, all dimensions
• Geberit Volex pressing system, all dimensions
The Geberit pressing tool is exclusively intended to be used in
accordance with these operating instructions. Other uses are deemed
to be improper and can lead to serious injury or death.
The Geberit pressing tool is not intended for:
• use with other manufacturers' pressing attachments
• use without pressing attachments inserted
The Geberit pressing tool together with Geberit pressing attachments
is not intended for:
• pressing objects other than those described in the operating
instructions, especially other manufacturers' pipes and pressfittings
User qualifications
Without suitable training, users cannot detect or may incorrectly
estimate the hazards presented by the Geberit pressing tool. They
are therefore at risk of seriously injuring themselves or others.
• Skilled persons qualified in pipe installations only may be permitted
to use the Geberit pressing tool.
• Users must be conversant with and apply country-specific safety
regulations.
18
27021600880296075-1 © 02-2018
968.243.00.0 (00)