Calibration - Caretalk DSO 364 Gebrauchsanweisung

Calibration

after approx. 10 measurements, the segment
indicator for CL (clean)
top left of the LCD display
backlight
2
twice and emit a signal tone twice to remind
the user that the probe tip with the infrared
sensor should be cleaned.
Calibration
The thermometer was calibrated in the factory
following manufacture. If the thermometer is
used in accordance with the provisions and
notices in the user manual for private and
non-commercial use, there is no need to cal-
ibrate it at regular intervals. If, however, you
doubt the accuracy of the measurements, you
should immediately contact your vendor.
− Never attempt to disassemble the ther-
mometer or make changes as this could
result in risks and in such a case, also void
any warranty claim.
42
will appear on the
21
of the thermometer will blink
and the green
1