Celsius/°Fahrenheit Setting; Date And Time Setting - Caretalk DSO 364 Gebrauchsanweisung

4. Then push the SET button to save this set-
ting. The thermometer will now return to
standby mode and will now automatically
switch off approx. 1 minute after the last
button activity.
5. If you would like to set the thermometer
back to continuously standby mode, you
can set the LCD/OFF setting to ON according
to the description above.
°Celsius/°Fahrenheit setting
1. Push the MEM button
ory mode.
2. Then hold the SET button
approx. 2 seconds until the temperature
measurement/indicator switches from °C
(degrees Celsius) to °F (degrees Fahren-
heit/1 signal tone) or vice-versa from °F
(degrees Fahrenheit) to °C (degrees Cel-
sius/2 signal tones).

Date and time setting

In standby mode and in memory mode, the
thermometer displays the room temperature,
time and date in alternation. The two blinking
dots between the hours and minutes indicate
the second intervals.
1. Push the SET button
2 seconds to switch to the configuration
mode. The indicator for the time mode
12 hour (12 hr) or 24 hour (24 hr) will blink.
Basic functions
to switch to mem-
9
down for
3
down for approx.
3
27