Cleaning, Maintenance, Storage And Ordering Of Spare Parts - EINHELL TC-PG 10/E5 Originalbetriebsanleitung

•
Check the fuel level and top it up if
necessary
•
Make sure that the generator has sufficient
ventilation
•
Make sure that the ignition cable is secured
to the spark plug
•
Inspect the immediate vicinity of the
generator
•
Disconnect any electrical equipment which
may already be connected to the generator
Mixture R egular
unleaded
Petrol
1 l
2 l
1:40
3 l
4 l
6.1 Starting the engine
•
Open the petrol cock (8) by turning it down
•
Move the ON/OFF switch (5) to position „ON"
with the key.
•
Move the choke lever (4) to position
•
Start the engine with the reversing starter (7)
by pulling the handle forcefully. If the engine
does not start, pull the handle again.
•
Push the choke lever (4) back again after the
engine has started.
Warning!
When starting with the reserve starter, the motor
may recoil suddenly as it starts up, resulting in
hand injuries. Wear protective gloves when
starting the equipment.
6.2 Connecting consumers to the generator
Connect the appliance you want to use to the 230
V~ socket.
Notice! This socket may be loaded continuously
(S1) with 680W and temporarily for a maximum of
1 minutes with 800W. The generator is suitable
for 230 V~ a.c. appliances.
generator to the household network as this may
result in damage to the generator itself or to other
electrical appliances in your home.
Note: Some electrical appliances (power jigsaws,
drills, etc.) may have a higher level of power
consumption when used in diffi cult conditions.
Anl_TC_PG_10-E5_SPK9.indb 21
GB
6.3 Switching off the engine
•
•
•
2 - stroke - This shuts down the socket (6). You can
Oil reactivate the socket (6) by pressing the overload
cut-out (3).
25 ml
Notice! If this happens, reduce the electric power
you are taking from the generator or remove any
50 ml
defective connected appliances.
75 ml
100 ml 7. Cleaning, maintenance, storage
Switch off the motor and pull the spark plug boot
from the spark plug before doing any cleaning
and maintenance work on the equipment.
.
Notice! Switch off the machine immediately
and contact your service station:
of unusual vibrations or noise
•
•
•
•
•
•
Do not connect the
7.2. Air fi lter (Fig. 5/6)
•
•
•
- 19 -
Before you switch off the generator, allow it
to run briefly with no consumers so that it
can
„cool down"
Move the ON/OFF switch (5) to position
„OFF" with the key.
Close the petrol cock Notice! The generator
is equipped with an overload cut-out.
and ordering of spare parts
If the engine appears to be overloaded or
misfires 7.1 Cleaning
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
We recommend that you clean the device
immediately each time you have finished
using it.
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could
attack the plastic parts of the equipment.
Ensure that no water can seep into the
device.
The air filter should be cleaned after every
30 hours of operation.
Remove the air filter cover (Fig. 5).
Remove the filter element (Fig. 6).
•
In the event
07.11.2019 10:00:21