EINHELL TC-PG 10/E5 Originalbetriebsanleitung Seite 18

•
40 °C, max. altitude above sea level 1000 m,
relative humidity: 90 % (non-condensing)
•
The generator is driven by a combustion
engine, which produces heat in the area of
the exhaust (on the opposite side of the
sockets) and the exhaust outlet. You should
therefore keep clear of these surfaces
because of risk of skin burns.
•
Fuel is combustible and highly flammable.
Do not fill up while in operation.
•
Some parts of the reciprocating internal
combustion engine are hot and can cause
burns.
The warnings on the generating set must be
observed.
•
If it is installed in ventilated rooms, the
additional requirements relating to protection
against fire and explosions must be
observed.
•
Before use, the generating set and its
electrical equipment (including cables and
plug connections) need to be checked to
ensure that they are not faulty.
•
The generating set must never be connected
to any other source of electricity such as the
electricity supply from a power supply
company. In special cases where a back-up
connection to existing electrical systems is
intended, this may only be carried out by a
qualified electrician who takes account of the
differences between the operated equipment
used by the public power grid and that used
for the operation of the generating set. It is a
requirement of this part of ISO 8528 that the
differences must be specified in the
instructions.
•
Given the high mechanical loads, only hard-
wearing rubber-insulated cables (in
accordance with IEC 60245-4) or equivalent
equipment should be used.
•
Warning! Observe the regulations on
electrical safety applicable to the area in
which the generating sets are used.
•
Warning! Observe the requirements to be
met and precautions to be taken if restoring
power to a system using generating sets in
dependency on the safety measures for the
system and the applicable directives and
guidelines.
•
Generating sets should only be used up to
their nominal power rating under the rated
Anl_TC_PG_10-E5_SPK9.indb 18
GB
ambient conditions. If the generating set is
used under conditions which do not meet the
reference conditions required by ISO 8528-8
and if this impairs the cooling of the engine
or the generator, e.g. as a result of operation
in restricted areas, the output must be
reduced. Information should be provided to
inform the user about the reduction in output
required as a consequence of higher
temperatures, installation height and air
humidity in comparison to the reference
conditions.
•
The values quoted in the technical data for
- 16 -
sound power level (LWA) and sound
pressure level (LWM) are emission values
and not necessarily reliable workplace
values. As there is a correlation between
emission and immission levels, the values
are not a reliable basis for deciding on any
additional precautions which may be needed.
Factors infl uencing
the actual user immission level include the
properties of the work area, other sound
sources etc., the number of machines and
other processes in the vicinity, as well as the
time span in which the operator is subjected
to the noise. Also, the permitted immission
level can vary from country to country.
Nevertheless, with this information the user
is able to make a better assessment of the
dangers and risks involved.
•
Never use a faulty or damaged electrical
equipment (this also applies to extension
cables and plug connections).
•
E lectric supply cables and connected
equipment must be in perfect condition.
•
The generator is to be operated only with
equipment whose voltage specifications
conform with the generator's output voltage.
•
Never connect the generator to the power
supply (socket-outlet).
•
Keep the cable length to the consumer as
short as possible.
•
Dispose of soiled maintenance material and
operating materials at the appropriate
collection point.
•
Recycle packaging material, metal and
plastics.
07.11.2019 10:00:21