Click Codes - Konig + Neurath LIFE.S Serie Bedienungs- Und Montageanleitung

Click codes

When the control unit is switched on its relays to inform the user
acoustically about the system state and the reason why the control
unit was switched off before. The table below shows which number
of clicks corresponds to certain information.
Number of clicks
1x
2x with short interval
(fast double click)
2x with long interval
(slow double click)
3x with short interval
(fast triple click)
3x with long interval
(slow triple click)
State information
Key lock active:
This signal will be put out every time if the
desktop shall be moved and the key lock is
active. (Up/Down-Key or memory keys)
Normal operation:
No problems detected. This signal will be put
out only when the control unit is connected to
mains power.
Reset mode:
The system was put into reset mode. This
signal will be put out every time if the desk-
top shall be moved in reset mode.
(Up/Down-Key or memory keys)
Sensor missing:
The safety sensor is not connected to the
control unit. This signal will be put our every
time if the desktop shall be moved.
(Up/Down-Key or memory keys)
Duty cycle exceeded:
This signal will be put out every time it the
desktop shall be moved downwards.
(Down-Key)
37