Manual Reset - Konig + Neurath LIFE.S Serie Bedienungs- Und Montageanleitung

Reset (manual reset)
When getting started or in the case of malfunction (e.g.power cut)
As the control panel will automatically switch to energy save mode
after a few seconds, it has to be deactivated first.
To do this, press the UP or DOWN button briefly. Now press the UP
and DOWN buttons at the same time and hold down until the desk
switches off automatically.
Successful reset is confirmed by an audible signal from the control
panel. Now release the buttons. The motorised height adjustment
feature of this desk can be used normally again.
Safety instructions:
During the reset process, the collision cut-out
is inactive! Beware of the risk of crushing.
Please ensure that there are no objects or
persons in the hazard area (the total potential
lift and movement area for all components) and
that they cannot be pulled into the hazard area.
Further information on motorized or manual
controls can be found at www.kesseböhmer.com
32