Hm 8131-2 - Hameg HM 8131-2 Handbuch

Functions Generator HM 8131-2
The HM 8131-2 Synthesizer Function Generator features simple
and intuitive operation requiring no learning period at a hitherto
unequalled low price. The most important functions frequency,
amplitude, offset voltage, sweep mode are controlled either
by a front panel knob or using the keyboard . All other functions
I I I I I
Standard signals: sine, square wave, triangle,
ramps
I I I I I
12 digit frequency display on back-lighted LCD
I I I I I
Arbitrary functions up to 10 MHz as defined by the
user
I I I I I
12 bit resolution amplitude, 40 MSa/s sample rate
at output
I I I I I
4 K non-volatile plus 16 K volatile memories
I I I I I
Interface for SRAM cards (up to 1 MB) storing
arbitrary functions
I I I I I
RS-232 interface for pc control. IEEE-488 interface
optional.
I I I I I
White noise with 10 MHz bandwidth
I I I I I
Pink noise with 100 kHz bandwidth
I I I I I
External triggering resp. gating allow burst mode
I I I I I
Linear or logarithmic sweep triggered or gated
I I I I I
Direct Digital Synthesis signal generation
Subject to change without notice
Downloaded from www.Manualslib.com manuals search engine
are accessible through menus shown on a back-lighted LCD
display.
The RS-232 interface allows fetching all data from as well as
control of the instrument thus enabling the incorporation of the
instrument in automated test sites.
I I I I I
Frequency range 100 µHz to 15 MHz with 100 µHz
I I I I I
30 µHz accuracy, temperature stability 2 ppm (0.5
ppm optional)
I I I I I
FSK and PSK modulation within the full frequency
range
I I I I I
Phase control in 0.1 degree steps referenced to the
control signal
I I I I I
Output voltage 20 V no load, 10 V
pp
offset selection up to ± ± ± ± ± 5 V
I I I I I
Master-slave operation of up to 3 function
generators

HM 8131-2

50 ohms. DC
pp
45