Operate Gemini Utilities; Start Gemini Utilities; Change The Autoloader Display Name; Enable The Beeper - Rimage Professional 3400 Bedienungsanleitung

Operate Gemini Utilities

The Rimage software includes an application called Gemini Utilities, which is used to change the display name of the system
and to enable the beeper. Gemini Utilities is only available on the Professional 5400N and the Professional 3400 running
Rimage Network Software Suite.
Tip: To access Gemini Utilities for the 5400N, use the remote desktop connection from a networked PC, or connect a
monitor, keyboard, and mouse to the 5400N.
 Note: Unless otherwise indicated, all Windows navigation statements are Windows XP paths. Other Windows operating
system navigation may differ slightly.

Start Gemini Utilities

1. Close all open software applications and stop all Rimage
Services.
 Note: Refer to your Rimage software online help for
additional information.
2. From the Windows Start menu select: All Programs >
Rimage > Utilities > Gemini Utilities. Gemini Utilities opens.
 Note: When the desired tasks are complete, start the
Rimage Services.

Change the Autoloader Display Name

Use Gemini Utilities to enter the name displayed on the operator
panel.
 Note: Changing the display name does not change the
name of the system on a network or workgroup. To change
the name on a network or workgroup, refer to your setup
and installation instructions or the Rimage Advance Setup
(Networking) Guide.
1. Select the Override Name checkbox.
2. Clear the Use Computer Name checkbox.
3. In the Display Name field, enter the new name.
4. Select Set Params to set the name.

Enable the Beeper

You can change the number of beeps that occur when the unit is out of media or when there is an error.
1. In the # of Beeps on Fault field, select the number of beeps you wish to hear when there is an error.
Tip: To disable the beeper, set the number to zero.
2. Select Set Params to set the number of beeps.
2001431_B
Downloaded from www.Manualslib.com manuals search engine
41