Install The Print Ribbon - Rimage Professional 3400 Bedienungsanleitung

Install the Print Ribbon

1. Remove the new print ribbon from the packaging.
2. Install the print ribbon on the print ribbon carrier.
-
Important! When you install the new print ribbon on the carrier, do not rotate the ribbon past the black cleaning
bars. When the new ribbon is installed in the integrated Everest 400 printer, the ribbon advances and the bars clean
the print head.
a. With the supply roll on the right side, unwind several inches of the new print ribbon.
b. Place the print ribbon on a clean, flat surface.
c. Place the print ribbon carrier on top of the print ribbon.
Tip: To keep the print ribbon carrier in place while you install the print ribbon, position the carrier so that the
tab rests on the edge of a table or workspace.
d. Bring the supply roll up and around the tacky roller
and guide rollers on the right side of the carrier.
e. Press down to install the supply roll, as shown.
f. Bring the take-up roll up and around the
guide roller on the left side of the carrier
g. Press down to install the take-up roll, as
shown.
2001431_B
Downloaded from www.Manualslib.com
New Take-Up Roll
Tab
manuals search engine
New Supply Roll
Take-Up
Roll
Guide
Roller
Supply Roll
Tacky
Roller
Guide
Roller
29