Safety Precautions; Air Supply; Installation; Assembly Prior To Installation - Jøtul F 100 Montage- Und Bedienungsanleitung

ENGlish
3.0 Safety precautions
3.1 Fire preventive measures
Any use of the fireplace may represent some danger.
Therefore, respect the following instructions:
• Ensure that furniture and other combustible materials
do not get too close to the fireplace.
• Let the fire die. Never extinguish it with water.
• The fireplace gets warm when used and may cause
burns if touched.
• Ash must be properly disposed of outdoors, or emptied
where it does not present a fire hazard.
3.2 Air supply
Warning! Please ensure that there is adequate air supply
from the outdoors to the room in which the fireplace is
to be installed.
Ensure that air vents in the room where the fireplace is
located are not blocked.
An inadequate air supply could cause smoke gas to escape
into the room. This is very dangerous! Symptoms of this
include smoky smell, drowsiness, nausea and feeling ill.
Avoid using mechanical fan vents in a room with a
fireplace. This may cause negative pressure and draw
poisonous gasses into the room.
16
Downloaded from www.Manualslib.com manuals search engine

4.0 Installation

N.B. Check that the fireplace is free of any damage prior
to commencing installation.
The product is heavy! Make sure you have assistance when
erecting and installing the fireplace.
4.1 Assembly prior to installation
• The product is delivered in a single packing case where
the smoke outlet, ash lip and door bolt knob must be
assembled.
• Once you have unpacked the product, remove all loose
parts. Check that the product does not have any visible
damage and that the operating handles work.
N.B. The top plate only rests on the product and shall not
be attached to it.
Rear mounted flue pipe
If the flue pipe is to be rear mounted do the following:
1. Lift off the top plate.
. Cut out a hole in the heat shield at the back for the flue
pipe (fig. 3).
3. Unscrew the two screws holding the flue outlet in
position from under the top plate (fig. 4A).
4. Unscrew the two screws holding the cover for the rear
outlet from the inside. (Hold the cover when removing
the last screw) (fig. 5A).
5. Swap the cover and flue outlet cover.
6. Place the top plate back in position.
7. Install the ash lip by hanging it under the door.
8. Screw the door knob on the handle. (Place the white
washer between the handle and the knob.)
9. Remove the protective paper from the gasket and
fasten it around the outside of the flue pipe.
10. Mount the flue pipe into the flue outlet.
N.B. It is important that the joints/flue pipes are
completely sealed. Air leaks can prevent the flue pipe from
functioning properly.
Top mounted flue pipe
If the flue pipe is to be top mounted do the following:
1. Attach the flue outlet to the top plate using the two
screws. Fig. 4-A.
. Install the ash lip by hanging it under the door.
3. Screw the door knob on the handle. (Place the white
washer between the handle and the knob.)