Safety Precautions; Fire Preventive Measures; Air Supply; Installation - Jøtul F 601 N Montage- Und Bedienungsanleitung

ENGLISH

3.0 Safety precautions

3.1 Fire preventive measures

When using your stove always follow these safety
precautions:
• Never overfire the stove. This may cause serious
damage to the stove and the chimney.
• Never use gasoline or similar liquids to start a fire in
this heater.
• Avoid creating a "low pressure" condition in the room
where the stove is operating, because this could cause
poisonous gases to be drawn into the room.
• Never extinguish the flames or ashes with water during
use as this may damage your stove and possibly cause
injury to yourself.
• Make sure that the furniture and other flammable
materials do not get too close to the stove.
• Ash should be placed outdoors or be emptied in a place
where it will not represent a potential hazard.
• Be careful in using your stove because it is very hot.

3.2 Air supply

Warning! Please ensure that there is adequate ventilation
in the room in which the stove is to be installed.
An inadequate air supply could cause smoke gas to escape
into the room. This can lead to drowsiness, nausea and
sickness and is extremely dangerous.
8

4.0 Installation

Check the stove to ensure that it is free of any damage in
transit before commencing with the installation.
The productis heavy! You will need help during assembly and
when the product is being placed into position.

4.1 Assembly prior to installation

Assembling the stove
1. Remove the cooking plate and all the separate parts
inside the stove. (Fig. 2.)
2. Place the cardboard packaging on the floor and lay the
stove carefully down on its side. Fasten the 4 legs with
screws and washers. (Fig. 3.)
3. Fasten the heat shield in the centre screw under the
fire place. Raise the stove carefully.
4. The flue outlet and the cover plate exchange positions
if the smoke outlet on top of the stove is preferred. (Fig.
4.) The two screws on the flue outlet may be somewhat
difficult to release. Hold on to the nut on the inside with
a small wrench of the flue outlet to release the screws
on the outside. Ensure all possible unused flue outlets are
suitably blanked off.
5. Connect the knob to the door latch with the screw and
nut provided. (Fig. 2A)

4.2 Floor

Foundations
Ensure that the floor is strong enough for the fireplace.
See «2.0 Technical data» for weights.
Wooden floor protection
Requirements for the floor plate:
The floor plate must be in accordance with national laws
and regulations. (See Buildings Regulations.)
We recommend that you contact the local Jøtul dealer prior
to installation.
Requirement for protecting combustible
flooring in front of fireplace
The front plate must be in accordance with national laws
and regulations.

4.3 Walls

Distance to non combustible wall -see fig. 1
A non combustible wall is here mentioned as a non load-
bearing wall of cement /brick.
Recommended distance to avoid discolouration of the wall,
easier cleaning etc.: 100 mm.