CASO DESIGN SV900 Original Bedienungsanleitung Seite 33

Setting the cooking temperature:
Press key once. The display shows the latest selected temperature and flashes.
This means that the value can now be changed. Use the keys (+/-) to set the cooking
temperature to the desired value. By keeping the arrow key pressed, you can change the
numbers more quickly. Temperature selection is possible as follows: 25-85°C (77°-185°F)
in increments of 0.1°C.
You can switch between C° and F° by longer pressing of button
Setting the cooking time:
To set the cooking time, press key " " (key 4). The LED display will indicate the time and
flash. Press the key (+/-) to increase / reduce the time. Time can be selected as follows:
00:00–99:00 hours. Use the keys (+/-) to set the cooking time to the desired value. By
keeping the key pressed, you can change the numbers more quickly.
When the desired time is reached, after 5 seconds the display will automatically display
the bin temperature.
Starting the cooking:
Select the cooking time and temperature and press key "
of the water. When the water reaches the selected temperature, alarms will sound, and the
key flashes. Please place the vacuum-packed foods into the bag holder and place it
into the bin. Make sure that the food is completely covered with water. Press
the cooking procress. The selected cooking time will be counted beginning at this time
point. When the cooking time is completed, the alarm will sound again. The food can then
be withdrawn.
► Risk of scalding! Carefully remove the food.
To check the remaining time during the cooking process, press key " " (Key 4) at any
time. You can change both cooking temperature and time during cooking. Proceed again
as described under "Setting the cooking time".
However, you can use the device also without setting the cooking time. Press key ' ' (Key
4) to activate the device. The unit will operate continuously without time limit if the cooking
time is set to 00:00. To stop or interrupt the cooking, press key "
To interrupt the power supply and switch off the device, press ' ' (Key 1) for one second.
To check the input made via the individual keys, press the respective key for a little more
than half a second.
► If the device should indicate "E001" in the LED display after switching on even though
the water filled in is above the minimum level, please add some salt to the water and stir
well.
Warning
Note: E001
.
" (Key 3) to start the heating
" (Key 3).
to start
33