Clock Setting; Timer Programming - Danfoss ECtemp Next Plus HW Installationsanleitung

ECtemp Next Plus HW
• Heating Equipment Control: The thermostat will switch
on the heating equipment when the water temperature
2 degree lower than the setting temperature, the LCD will
display "
setting temperature, the thermostat will switch off the
heating equipment. The icon "
8

Clock setting

• Clock setting: Press "
flash, press "
flash, press "
"week" flash, press "
9

Timer programming

• Weekdays Setting: When thermostat at Programming mode,
setting in the first period: press and hold for 5 seconds "
till to display "Mo Tu We Th Fr" and "hh:mm" and "hh" flash,
press "
" " till to display "hh:mm" and "mm" flash, press "
" " to adjust minutes in the first period; press "
temperature flash and the figure is the setting temperature
of first period. When setting temperature is lower than
35 °C, it will display "OFF". Using the above method to set
the hour and minute in other periods. Once the setting
time is over 16:00 at each period, it will switch to
weekend setting.
• Weekend Setting: "Sa Su" showing is weekend setting, the
setting method is same with above.
10 | © Danfoss | Produced by FEC | 2020.10
"; When the water temperature is equal with
" or "
" or "
" or "
" or " " to adjust hour in the first period; press
"will disappear.
" till to display "hh:mm" and "hh"
" to adjust hour, press "
" to adjust minute; Press "
" to adjust Mon to Sun.
", "mm"
",
" or
", the
AN347136888492-010101
"