Preparing The Remote Control; Installing Batteries; When To Replace Batteries; Battery Precautions - Tascam BD-MP4K Bedienungsanleitung

Preparing the remote control

Installing batteries

1. Open the cover on the back.
2.
Insert two AAA batteries, being certain to use the correct
¥ and ^ orientations.
3. Close the cover.

When to replace batteries

Replace both batteries with new ones if the distance from the main unit
that the remote can be used decreases or if the unit stops responding to
the remote buttons.

Battery precautions

Misuse of batteries could cause them to leak or rupture, for example.
Carefully read and follow the battery caution labels.
(see "CAUTIONS ABOUT BATTERIES" on page 6)

Using the wireless remote control

See "Wireless remote control (TASCAM RC-BDMP4K)" on page 13 for the
button functions.
When using the remote control, point it toward the receiver on the unit
and use it within the range shown below.
Remote control signal receiver
Remote control operation range
Up to 10 m from front
From any angle within 15º of front
ATTENTION
i Operation might not be possible if there are obstacles.
i Remove the battery if not using the remote control for a long
time (a month or more).
i It battery fluid should leak, wipe away any fluid inside the
case thoroughly and install a new battery.
i When using other devices that can be controlled by infrared
rays, operation of this remote control could cause those
devices to function improperly.

Turning the unit on and off

NOTE
When the power cord is connected to the unit and power is
supplied from an outlet, the unit will start up automatically
when it receives power. (This will also happen when power
supply resumes after a power outage or the main power has
been off for another reason.)
When the STANDBY/ON indicator on the front of the unit is lit,
press the button or the remote control STANDBY/ON button.
Startup Screen
HELLO
Lock Status Display Screen
LOCK: OFF
Active Screen
BDMV
After the unit starts up and the Startup Screen is shown
followed by the Lock Status Screen for three seconds, the Active
Screen will open.
Turning the unit off
Press the button on the front of the unit or the remote
control STANDBY/ON button to turn the unit off.
During shutdown, the Shutdown Screen will appear. When
shutdown completes, the display will turn off, and the
STANDBY/ON indicator will light red.
ATTENTION
Do not turn the power off or disconnect the power cord
when the unit is operating (including playing back or writing
data to a USB flash drive). Doing so could damage the unit.
29
TASCAM BD-MP4K