Loading And Removing Discs; Loading Discs; Ejecting Discs; Inserting And Removing Sd Cards - Tascam BD-MP4K Bedienungsanleitung

Loading and removing discs

Loading discs

Press the OPEN/CLOSE ( - ) button on the main unit or remote
control.
Open the disc tray and place the disc on it with the label side up.
Press the OPEN/CLOSE ( - ) button again to close the disc tray.
After a disc is loaded, the unit will read its data.
will appear on the display while the disc is being loaded.
LOAD
The following will be shown when loading completes.
o Blu-ray disc:
o DVD:
o Audio CD:
o DATA CD, etc.:
NOTE
i When the disc tray is open,
display. (While the disc tray is being closed,
appear on the display.)
i If a disc other than a playable CD is inserted or a disc is
inserted upside down, the unit will automatically eject it.

Ejecting discs

Press the OPEN/CLOSE ( - ) button on the main unit or remote
control.
After the disc tray opens, pick the disc up by its center and
remove it.
NOTE
The OPEN/CLOSE ( - ) button functions when the unit is
turned on.
30
TASCAM BD-MP4K
OPEN/CLOSE button on main unit
OPEN/CLOSE button on remote control.
or
BDMV BDAV
DVD
CD
DATA
will appear on the
OPEN
CLOSE

Inserting and removing SD cards

Inserting SD cards

Insert an SD card into the SD card slot on the front of the unit to
enable playback.
NOTE
SD cards can be inserted whether or not the unit is on or off.
i Inserted SD cards with the correct orientation.
i The label should be up and the connector should be
inserted toward the back.

Removing SD cards

Turn the unit off or stop operation before removing an SD card.
CAUTION
Do not remove an SD card when the unit is operating
(including playing back). Failure to do so could cause data
loss and sudden loud noises from monitoring equipment,
which could damage the equipment or harm hearing.
1.
Press the SD card in gently to make it come out.
2. Pull the SD card out by hand.

SD card write protection switches

SD cards have write-protection switches that prevent writing
new data to them.
will
Connecting and disconnecting USB
flash drives

Connecting USB flash drives

Connect a USB flash drive to the USB port on the front of the
unit to enable playback.
NOTE
You can connect a USB flash drive when the unit is on or off.

Disconnecting USB flash drives

Turn the unit off or stop operation before disconnecting a USB
flash drive.
ATTENTION
Never disconnect a USB flash drive when the unit is operating
(including playing back or writing data to the USB flash
drive). Doing so could cause the loss of data or damage the
unit.