Using The Test Tone - Tascam BD-MP4K Bedienungsanleitung

Using the test tone

Test tones (white noise) can be output from each speaker to confirm
their connections and adjust their trim values. They can also be used to
change sizes and delay values.
1. On the Home Screen, select Settings > Audio settings >
Speaker settings > Test Tone. This opens a Speaker Setting
Screen with the currently set channel configuration.
Example with 7.x and C+LR+LssRss+LsrRsr settings
This outputs a test tone from the speakers in
counterclockwise order starting from the L speaker.
Example: when set to 7.x and C+LR+LssRss+LsrRsr,
tones will be output in this order:
L w C w R w Rss w Rsr w Lsr w Lss w L.
2. Press the ENTER button while a speaker is highlighted
yellow to enable changing its speaker size, trim and delay
settings.
The current size, trim and delay settings for the highlighted
speaker and its paired speaker will be shown at the bottom
left of the screen.
3.
Use the same procedures as for channel configuration to
adjust the size, trim and delay.
NOTE
The test tone cannot be used to adjust the subwoofer.
42
TASCAM BD-MP4K