Use / Version - Valeo Thermo AC Einbau- Und Betriebsanweisung

Thermo AC 2nd generation
3

Use / Version

The electrical heater can be used in a depot for pre-heating purposes.
For this it is connected stably to the depot mains 3/PE/N AC 400/230V
50Hz.
Further more the heater also can be used in electric driven buses or
hybrid buses where a 3/PE/N AC 400/230V 50Hz power supply is pro-
vided, in association with the vehicle's own heating system:
– to heat the passenger cabin, and
– for pre-heating.
The heater may only be installed and operated in vehicles of the class
M2, M3.
Any use beyond is not permitted.
The heaters operate independently of the vehicle engine and are
connected to the vehicle's cooling and electrical systems.
Warning!
The heater is not approved for use in vehicles carrying dangerous
goods according to Annex 9 of the UN/ECE Regulation R122.
Danger to life and health!
General Information / Safety
Check the information given on the rating plate of your heater / in the
technical data and compare this with your mains voltage!
In addition to the statutory regulations the specific connection conditions
of local electricity companies are to be observed.
No alterations to the electrical installation may be undertaken.
The installation and commissioning may only be carried out by a quali-
fied electrician.
Only have any work on the appliance carried out by a specialist
company or a qualified person.
The installation instructions are to be considered.
Caution!
Under no circumstances touch the heat exchanger and the water
hoses during operation, in particular when they are overheated due
to lack of water.
Ensure an adequate distance to all surrounding parts and a sufficient
ventilation during installation.
Alternately use fire resistant materials or heat shields (see Statutory
Regulations governing installation, para. 5.3.2.2).
Use / Version
Hot surfaces!
31