Rotary Mode - LaserLiner DualAxis-Laser Bedienungsanleitung

Laser modes
These modes can also be controlled with the Commander DAL 50 at distances
of up to 50 m away from the unit. To insert the battery, open the compart-
ment completely (as shown on the right). Make sure that you do not reverse
the polarity. Replace and close the cover completely.
Laser Area Mode:
• The operating range of the laser beam can be divided into segments. The
individual segments of the laser beam can be deactivated. This is important
if a number of rotary lasers are in use on the same site.
• Use the segment button (30) to select the 4 segments and the plus/minus
buttons (28) to activate or deactivate the required segment.
• Confirm the setting by pressing Enter (29). This will restrict the laser's active
range to the required segments.

Rotary mode

You can use the rotation button (35) to set various speeds:
0, 300, 600, 1100 rpm.
Hand receiver mode
Working with the optional laser receiver: Press 17 to switch
the SensoLite laser receiver on. Set the maximum speed of
1100 rpm using the Commander DAL 50 or on the rotary
laser (button 35).
The laser receiver is now able to detect the laser beam
reliably over long distances. Move the laser receiver up and
down through the laser beam until the middle indicator (13)
appears. Mark the measured height at the perimeter marking
groove.
SpotLite Marking: The projected light beam at the height
of the laser beam simplifies precise marking and prevents
parallax errors.
ENGLISH
DualAxis-Laser
27