Adjustment Mode - LaserLiner DuraMax Bedienungsanleitung

Adjustment mode

1. Take the alignment of the rotary laser into account when performing adjustment work.
Always adjust all the axes.
2. Switch the device to adjustment mode:
Switch off DuraMax then switch it on again (press the ON/OFF button briefly) while
holding down the slope/man button. Keep the slope/man button pressed until the
tilt LED flashes. Then the slope/man button can be released.
Use the X/Y button on the Commander 50 to toggle between the X and Y axes.
Alternatively, you can toggle between the X and Y axes using the positioning
button (rotate to the right on Commander 50 or SensoCommander).
3. Correcting the adjustment:
With the plus/minus buttons on the adjustment panel of the Commander 50, you
can move the laser away from its current position to the level of reference point A2.
4. Completing the adjustment:
Cancel: Switch the rotary laser off (via the ON/OFF button) to reject all adjustment
settings and restore the previous status.
Save: The new adjustment settings are saved by pressing the enter button on the
Commander 50.
Alternatively, you can save the new adjustment settings with the positioning button
(rotate to the left on Commander 50 or SensoCommander).
Adjustment panel
Regularly check the adjustment before use, after transport
!
and after extended periods of storage. Always make sure to
control all axes.
DuraMax / DuraMax XPro
X- / Y-
Axis
X
Y
GB 21