Inhaltsverzeichnis
Werbung
BATTERY INSTALLATION
Home Receiver:
Main Power Source: Plug in the 4.5V adapter into the adapter socket at the back for basic
operation and continuous backlight.
Backup Power: Lift off the battery cover at the back, install 2 pcs AA batteries according to the
polarity indicated, close the battery cover.
Remote Sensor:
Lift off the bracket stand, loose the 4 screws with a small screwdriver, insert 2 pcs AAA
batteries according to the polarity indicated. Replace the cover and tighten the 4 screws.
RADIO-CONTROLLED CLOCK
The unit will start synchronizing the clock after the 1st channel of the RF thermometer is
registered. At normal mode, hold "-/
The antenna icon will appear during synchronization, if the icon disappear afterwards,
radio time signal is not available at the moment. Try other locations later. Place
the unit away from source of interference such as mobile phones, appliances, TV etc.
Antenna icon will appear fix on screen if the radio time reception is successful. The radio-
controlled clock will have a daily synchronization at 01:00 everyday. Maximum 4 more
attempts at one hour interval. Each reception cycle is minimum 1.5 minutes and maximum 4
minutes.
SETTING UP THE WIRELESS THERMOMETER:
• For the first installation, always insert batteries to the home unit and then the remote
sensor. Your new RF Thermometer is build with random security code technology, the
home unit will learn the random code of the first remote sensor and log in as Channel 1.
Channel 2 and Channel 3 will be registered in the same way.
• A registered channel will not accept any new sensors. The registered channels will be
erased when the batteries of the remote sensor or the home unit are removed.
• When replacing batteries for the remote sensor, remember to clear the corresponding
channel of the home unit by removing the batteries or in this way: Select the respective
channel by pressing the CHANNEL button, hold the CHANNEL button 3 seconds to clear
the registration.
• When replacing batteries for the home receiver, please remove batteries of all remote
sensors and re-install the batteries to the sensors according to the desired
channel sequence.
• Press the Tx button on the back of remote sensor to verify the RF reception, hold the
button 3 sec to reset.
C/ F SELECTION
By holding "SET/ZONE" 3 seconds, enter the setting mode to select C and F.
CLOCK & CALENDAR SETTING
Hold "SET/ZONE" button for 3 seconds to enter clock set. Using "+ , -" to adjust and
"SET/ZONE" to confirm, the following values can be set in sequence: 12/ 24 hr > C/F > Yr
> Month > Date > Language > Hour > Minutes > Time Zone Offset > Confirm & Exit.
W182 SNPMEB.indd 16
Downloaded from
www.Manualslib.com
manuals search engine
" button 3 seconds for force synchronization.
16
3/15/07 4:22:58 PM
Werbung
Inhaltsverzeichnis
