Zero Operation; Manual Tare; Weighing Mode; Sleep Mode - OHAUS Valor 1000W Serie Bedienungsanleitung

TM
EN-4 OHAUS Valor 1000W Series
Note:
• Charging the scale must be performed in a dry environment.
• After charging, re-install the rubber seal to the power input jack (Figure 1-1, item
9) to ensure the scale is protected when operating in a wet environment.
3. OPERATION
3.1 Turning Scale On/Off
To turn the scale on, short press the On/Off button. The scale momentarily displays
software version, performs a display test then enters the active weighing mode.
To turn the scale off, long press the On/Off button.

3.2 Zero Operation

Zero is set under the following conditions (see Section 4.2 to select Initial Zero and
Key Zero ranges):
• Automatically at Power On (initial zero)
• Manually by pressing the ZERO button
Press ZERO to zero the stable weight display.

3.3 Manual Tare

Place a container on the weighing pan, then press TARE. The display will show a
net value of "0". To clear the Tare value, press TARE with the pan empty.

3.4 Weighing Mode

Use this mode to measure the weight of a sample in the selected unit of measure
(see Section 4.2 to select unit). Press ZERO to set the display to zero. Put an empty
container on the pan as needed, then press TARE to tare the container weight. Add
material to the container. The display shows the weight of the material in the
selected unit of measure.

3.5 Sleep Mode

Whether on AC power or batteries, with the pan empty and the scale stable and
inactive for 1 minute, the display digits will turn off and show only a blinking
decimal.
Downloaded from www.Manualslib.com manuals search engine