OHAUS Valor 1000W Serie Bedienungsanleitung Seite 10

EN-8
4.3 Restore Settings to Default
Press and hold SET, then
default user settings [F1-0 x].
Press YES to confirm displayed setting and proceed to next menu item.
Press SET to save and exit.
4.4 Set Tare Capacity
Press and hold SET, then
tare capacity settings [tArE x], where x:
0 = 2/3 of scale capacity
1 = 100% of scale capacity
Press
5. SCALE SETUP AND SPAN CALIBRATION
For best results, calibrate the scale at regular intervals. Temperature changes,
gravity variations and abuse are some reasons why a scale may need recalibration.
Enter calibration as follows:
• Turn the scale on.
• During the start-up display [000000...999999], press and hold SET until
[FS--SP] is displayed.
• Press YES to display [P
• Press
• Press YES to select, then display [d
• Press
• Press YES to select, then display scale capacity [xxxxxx] (kg)
• Press YES to select, then display [noLoAd]
• Make sure pan is empty, then press YES to display [LoAd]
• Press YES to select, then display default or last used span weight [xxxxxx] (kg)
• Press
• Place indicated weight on the scale, then press YES
• [CALEnd] is momentarily displayed to indicate calibration was successful, then
exit to weighing mode
• To abort calibration at any point, turn the scale off.
Examples:
Parameters:
P
d
Capacity
Downloaded from www.Manualslib.com
until [SEt-F2] is displayed. Press YES to enter and view
until [SEt-F3] is displayed. Press YES to enter and view
to toggle through available settings, then press SET to save and exit.
x], where x = position of decimal point
to toggle through settings: 0, 1, 2, 3, 4
to toggle through settings: 1, 2, 5, 10, 20, 50
, , to edit the displayed value (as needed)
3 x 0.0005 kg 6 x 0.001 kg
4
5
3.000 6.000
manuals search engine
OHAUS Valor
x], where x = scale divisions
15 x 0.002 kg
3 3
1 2
15.000
TM
1000W Series
30 x 0.005 kg 30 x 0.01 kg
3 3
5 10
30.000 30.000