Front Panel; Back Panel - LD Systems LD WSECO2X2 Bedienungsanleitung

LD WSECO2X2 RECEIVER:
VOLUME CONTROL CHANNEL 1
1
Turn the knob to the right to increase the
volume, to the left to reduce it.
RF INDICATOR CHANNEL 1
2
AUDIO INDICATOR CHANNEL 1
3
4
POWER INDICATOR
CHANNEL 2 XLR OUTPUT
1
CHANNEL 1 XLR OUTPUT
2
CHANNEL 2 MUTE LEVEL FINE ADjUSTMENT
3
Adjusting the receiver squelch setting:
The squelch setting of the receiver is adjusted at
the factory so that the system functions optimally.
Normally, no further adjustment is required. However,
it is possible to change this value to improve either the
signal quality or range of your system. please note:
If the mute level is increased, the receiver requires a
higher-quality signal (less noise in the signal), but the
6
Downloaded from www.Manualslib.com
CH.1
VOLUME
RF
MIN MAX
1 2
CHANNEL2 AF OUTPUT CHANNEL1 AF OUTPUT
XLR BALANCED -20dBV XLR BALANCED -20dBV
2
1
manuals search engine
CH.2
AUDIO POWER AUDIO
RF
3 4 5 6
RF INDICATOR CHANNEL 2
5
6
AUDIO INDICATOR CHANNEL 2
7
VOLUME CONTROL CHANNEL 2
Turn the knob to the right to increase the
volume, to the left to reduce it.
D.C.12-18V IN
400mA
CHANNEL 2 CHANNEL 1
+
MUTE LEVEL MUTE LEVEL
3 4
range is reduced. Reducing the mute level
causes the receiver to also transmit poorer
signals (more noise permitted before the
mute/squelch function takes effect). Simul-
taneously, system range increases.
AC ADAPTER INPUT
4
CHANNEL 1 MUTE LEVEL FINE ADjUST-
5
MENT
6.3 MM jACK MIX OUTPUT
6

FRONT PANEL:

VOLUME
MIN MAX
7

BACK PANEL:

2 IN 1 MIX
UNBAL OUTPUT
5 6