Important Safety - Partner P340S Betriebsanweisung

Your Chain Saw is provided with a safety
label located on the chain brake lever/hand
guard. This label, along with the safety
instructions on these pages, should be
carefully read before attempting to operate
this unit.
HOW TO READ SYMBOLS AND
COLORS (FIG.1)
WARNING:
an unsafe procedure
performed.
GREEN RECOMMENDED
Recommended cutting procedure.
Fig. 1
WARNING
1. Beware of kickback.
2. Do not attempt to hold saw with one
hand.
3. Avoid bar nose contact.
RECOMMENDED
4. Hold saw properly with both hands.
TOOLS FOR ASSEMBLY
You will need these tools to assemble your
chain saw:
1. Combination wrench-screwdriver (cont-
ained in your user's kit).
2. Heavy duty work gloves (user supplied).
ASSEMBLY REQUIREMENTS
WARNING:
engine until unit is properly prepared.
Your new chain saw will require adjustment
of chain, filling the fuel tank with correct fuel
mixture and filling the oil tank with lubricating
oil before the unit is ready for operation.
Read the entire user manual before
attempting to
particular attention
precautions.
Your user manual is both a reference guide
and handbook provided to furnish you
with general
operate and maintain your saw.
Downloaded from www.Manualslib.com

IMPORTANT SAFETY

DANGER! BEWARE OF KICKBACK!
dangerous loss of control of the chain saw
and result in serious or fatal injury to the
saw operator or to anyone standing close
by. Always be alert. Rotational kickback
and pinch-kickback are major chain saw
operational dangers and the leading cause
of most accidents.
RED Used to warn that
should not be
1 2
BEWARE OF:
3 4
ROTATIONAL
KICKBACK
(Fig. 2A)
A = Kickback path
B = Kickback
ASSEMBLY INSTRUCTIONS
GUIDE BAR / SAW CHAIN / CLUTCH
COVER INSTALLATION
gloves when handling chain.
TO INSTALL GUIDE BAR:
To ensure the bar and chain receive oil,
ONLY USE THE ORIGINAL STYLE BAR
with the oil passage hole (A) as illustrated
DO NOT start saw
above. (Fig.3A)
1. Make sure the CHAIN BRAKE lever is
2. Remove
operate your unit. Pay
to all safety
Note: Discard the two plastic washers. They
are only used for shipping the chain saw.
3. Using a screwdriver, turn the adjustm-
information to assemble,
4. Place the slotted end of the guide bar
-- 5 --
manuals search engine
WARNING:
Kickback can lead to
A
B
A
A A
B
C
Fig. 2A Fig. 2B
THE PUSH (PINCH
KICKBACK) AND
PULL REACTIONS
(Fig. 2B)
A = Pull
reaction zone B = Solid objects
C = Push
WARNING:
Always wear protective
pulled back into the DISENGAGED
position (Fig. 3B)
the bar retaining
(B). Remove the CHAIN BRAKE cover
(C) by pulling straight out, some force
may be required. (Fig.3C).
ent screw (D) COUNTERCLOCKWISE
until the TANG (E) (projecting prong) is to
the end of its travel (Fig. 3D).
over the bar bolt (F). Slide guide bar
behind clutch drum (G) until the guide
bar stops (Fig.3E).
nut