Before Operation; Cooking With Pre-Programmed Memories - Sharp R-8730-A Bedienungsanleitung

R-8730-A [Cov+Eng].qxd
LOCK FUNCTION
• Your oven has a lock function and is locked when
• The lock will be set when the oven is plugged in,
• To release the lock function, press the
• Your oven is already installed with 30 cooking
• The input is cancelled when any keys are not
• Heat the oven using the top and bottom grills
• The oven has 30 memory banks (1 - 30), the
• The total cooking times for each memory bank are
• In addition for all memory banks a reduce factor is
Downloaded from www.Manualslib.com
6/6/07 4:37 PM
you first connect to an electrical socket. At that time
the digital display will show:
you can use all functions except for the
MEMORY key.
MANUAL key and hold for 2 seconds until the
audible sound is heard. LOCK indicator will
disappear and you can use the MEMORY key.
To lock the oven press the MANUAL key and
hold for 2 seconds.
programmes for apetito products in each number
key. The first 20 programmes cannot be changed.
pressed for more than 3 minutes.
without food for 20 minutes. (For operation see
notes in GRILL COOKING, on page GB-10).

COOKING WITH PRE-PROGRAMMED MEMORIES

programme numbers of Memory are made
especially for deep frozen menus of apetito.
shown in the table on page GB-5. The memory
banks 21 - 30 can be changed individually if
required (see page GB-13).
stored. It is useful if you use the same memory in
the memory banks continuously.
manuals search engine
Page 9

BEFORE OPERATION

STOPPING THE OVEN
• or
the time reaches zero (e.g. at the end of the
cooking time).
STOP key is pressed. If you press the STOP key
twice during cooking
press the stop key again the display will return
to
.
LET THE OVEN COOL DOWN WHILE
IS DISPLAYED TO PREVENT OVER
COOKING.
• If you wish to stop the oven during cooking:
Press the STOP key once or open the door.
To start the oven again, close the door and press
the START key within 1 minute.
• If you wish to cancel a programme during cooking,
press the STOP key twice.
• If you wish to erase a mistake during
programming, press STOP key once.
The reduce factor is separately made for each
programme.
The stored reduce factor for 21 - 30 can also be
changed individually if required (see page GB-14).
• Information in these memory banks is not lost
during power interruptions. If the power goes off,
the oven does not need to be re-programmed.
Batteries are not necessary for this type of memory.
• To check the stored programmes or reduce factors
refer to "memory check" on page GB-15.
GB-4
will appear on the display after
will disappear when the
appears. If you