Kenwood AT910 Handbuch Seite 11

Downloaded from www.Manualslib.com
Question
The feed tube keeps blocking
The cutting assembly is difficult
to remove
The cutting assembly is difficult
to fit
manuals search engine
Answer/Hint
G
Add small amounts of pasta at a time
in a steady rate and only add more
when the feed tube is clear.
G
The mix is too wet.
G
Use the end of the spanner/pusher to
push the mix down the feed tube.
(Removing the hopper will enable the
spanner to reach lower down the feed
tube).
G
Vary the speed of adding the mix.
G
Leave the attachment to cool down
for approximately 30 minutes.
G
Make sure the metal clamp ring is
partially unscrewed from the plastic
inner before pushing onto the
attachment.
8