Bosch Sensixx B22L UltimatePower Gebrauchsanleitung Seite 19

F
Storing the appliance
1. Always allow the appliance to cool down before
storing it.
2. Set the main power button to the "0" position
(the red light will go off) and disconnect the
mains cable.
3. Empty the water tank.
4. Place the iron on the iron pad (1), standing on
the soleplate, and fix it by inserting the tip of
the iron into the front slot and moving the lock
lever (14) against the heel of the iron.
5. Store the mains cable in the storage
compartment (7) and the steam hose in the
storage fixing (3). Do not wrap the cords too
tight.
6. Use the iron´s handle when moving the
appliance, as shown in figure F.
Trouble shooting
Problem
Pilot light (11)
flashes
The steam
generator does not
come on.
The iron does not
heat up.
The iron begins to
smoke when
switched on.
Water flows through
the holes on the
soleplate.
Possible causes
• Boiler and filter must be rinsed.
• There is a connection problem.
• The main power button is not
switched on.
• The main power button is not
switched on.
• The temperature is set to a low
position.
• During first use: certain
components on the appliance
have been lightly greased at the
factory and may produce a little
smoke when initially heated.
• During subsequent use: the
soleplate may be soiled.
• The steam function is being used
before it has reached the correct
temperature.
• The water is condensing inside
the pipes because steam is being
used for the first time or has not
been used for a long time.
Tips to help you
save energy
Steam production consumes the most energy. To
help minimise the energy used, follow the advice
below:
• Start by ironing the fabrics that require the
lowest ironing temperature.
Check the recommended ironing temperature
in the label on the garment.
• Regulate the steam according to the selected
ironing temperature, following the instructions
in this manual.
• Try to Iron the fabrics while they are still damp
and reduce the steam setting. Steam will be
generated from the fabrics rather than the iron.
If you tumble dry your fabrics before ironing
them, set the tumble drier on the 'iron dry'
programme.
• If the fabrics are damp enough, turn off the
steam regulator completely.
Solution
• Rinse the filter and the boiler
according to the cleaning instructions
in this manual (see section E).
• Check the mains cable (6), the plug
and the socket.
• Set the main power button (12) to the
"I" position (illuminated in red).
• Set the main power button (12) to the
"I" position (illuminated in red).
• Set the temperature to the desired
position.
• This is completely normal and will
stop after a short while.
• Clean the soleplate according to the
cleaning instructions in this manual.
• Reduce the steam flow when ironing
at low temperatures.
• Point the iron away from the ironing
area and press the steam release
button until steam is produced.
19
BOS CH