Jura IMPRESSA XJ5 Professional Bedienungsanleitung Seite 16

Preparation
Hot water
Downloaded from www.Manualslib.com
Example: Proceed as follows to permanently set the amount of
water for one coffee.
Precondition:
o T Press and hold the coffee button.
o T Hold the coffee button down until
o T Release the coffee button.
E You can alter this setting at any time by repeating the above
E You can also permanently set the amount for all speciality
The following temperatures can be selected for preparing hot water:
REGULAR
J CAUTION
There is a danger of scalding from hot water splashes.
T
m
E By touching the Hot Water button several times m (within
manuals search engine
is displayed.
READY
T Place a cup under the coffee spout.
.
1 COFFEE
appears.
Preparation starts and the coffee flows into the cup.
T Press any button as soon as there is sufficient coffee in the
cup.
Preparation stops. appears briefly on the display. The set
OK
amount of water for one coffee is permanently stored.
appears on the display.
READY
procedure.
coffees, hot water and steam in programming mode (see
Chapter 'Permanent settings in programming mode –
Product settings').
, , .
NORMAL HOT
Avoid direct contact with the skin.
T Place a cup under the hot-water nozzle.
T Press the Hot Water button.
. The preset temperature is then briefly displayed.
WATER
approximately seconds) you can set the temperature to
your individual preference. This setting is not saved.
Hot water flows into the cup. Preparation stops automati-
cally. appears on the display.
READY
ENOUGH COFFEE ?