hanseatic HKGK18860DNFW Gebrauchsanleitung Seite 61

frigerant contained in your appliance can
be found on the type plate.
The minimum size of the area in which your
appliance is set up is as follows: 6.5 m³
– The appliance must only be placed on a
level and firm surface. The surface must be
strong enough to support the appliance's
weight when fully laden.
– Suitable locations are dry, well-ventilated
areas that are cool if possible.
– Unsuitable locations are ones with direct
sunlight or which are directly next to an
oven, hob or radiator.
About climate categories
• Always ensure the prescribed ambient temperature is maintained (see "Intended use" on
page EN-5).
Climate category means that the appliance is intended for operation at the specified ambient
temperature.
Zone description
Extended temperate zone
Temperate zone
Subtropical zone
Tropical zone
If the room temperature drops significantly below this, the unit will not switch on as often. This
indicates that an unwelcome increase in temperature may occur.
The following minimum distances must be
maintained:
– from electrical hobs
– from oil and coal burning stoves 30cm
– from other refrigerating appliances 2 cm
– from washing machines/
– If you would like to reduce these distances,
you can fit an insulation plate between the
appliances.
– If underfloor heating is installed at the set-
up location, place the cooling appliance on
an insulation plate made from solid mate-
rial.
Code Definition
SN This refrigerator is designed for use at ambient temper-
atures of +10 °C to +32 °C.
N This refrigerator is designed for use at ambient temper-
atures of +16 °C to +32 °C.
ST This refrigerator is designed for use at ambient temper-
atures of +16 °C to +38 °C.
T This refrigerator is designed for use at ambient temper-
atures of +16 °C to +43 °C.
Start-up
dishwashers
Page EN-23
3 cm
2 cm