Strong Digital TV SRT 4600 Bedienungsanleitung Seite 71

Premiere network scan
To start a Premiere network scan, press the
red button on your remote control while the
Network scan screen is displayed.
The channel scan starts immediately and
takes only a couple of minutes. When it is
complete, the Premiere network scan screen
appears with the word Done at the bottom.
This shows the number of carriers
(transponders) scanned and the number of TV
and radio channels found.
Press the OK button to save all the channels
that were found.
Downloaded from www.Manualslib.com
SCANNING FOR CHANNELS
manuals search engine
Full network scan
To start a Full network scan, press the blue
button on your remote control while the
Network scan screen is displayed.
The Scan satellite screen appears.
Use the buttons to highlight the
Scanning mode setting, then press the
buttons until the type of scan you want
(Exhaustive, Fast (NIT) or Frequency) is
displayed. If you choose the Fast (NIT) scan,
you can press the blue button to change the
settings, if required.
If you have a dish positioner, you can select
the satellite you want. Use the
highlight the Satellite setting, then press the
buttons until the one you want to scan is
displayed.
To change any of the Frequencies or Symbol
rates, first use the buttons to highlight
number. Then use the
digits and the number buttons to enter them.
To change the Polarisation, use the
buttons until the polarisation you want is
displayed.
When the scan is complete and the word
Done appears, press the OK button to save all
the channels that were found.
IMPORTANT: If you press the Exit button
while your set-top box is scanning, you will
lose all the channels that were previously
saved. You will therefore have to start a new
scan for channels.
buttons to
button to delete the
27