ZF 6008.208.450 Betriebsanleitung Seite 93

Connecting Bluetooth:
1. Select Bluetooth as connection type (4, refer to Chapter 2.4.6).
2. Supply the DPA06 with 12/24 V operating voltage.
3. Click on the "refresh" button (7, refer to Chapter 2.4.6). If needed, repeat process until the desired device is displayed on the
"Interface" list box (6, refer to Chapter 2.4.6).
4. Select the respective DPA06 (identification via serial number, refer to type plate on the back of the DPA06)
5. Click on the "Connect" button (10, refer to Chapter 2.4.6) to connect with DPA06.
6. The connection has been successful, if the firmware version is displayed correctly under "DPA" (2, refer to Chapter 2.4.6).
The stability of the Bluetooth connection can be affected by radio interferences, poor radio conditions, covers, etc. Thus,
when conducting long-term measurements (e.g. via datalogger or monitoring), interruptions and data loss can occur.
Use the USB connection for the flashing of transmission control units!
Make sure to create favorable radio conditions:
‒ PC and DPA06 within the range of vision.
‒ Short distance between PC and DPA06.
‒ Avoid radio-interference sources such as other Bluetooth, WiFi, or DECT devices, all devices working in the 2.4 or 5 GHz
frequency band, high-voltage cables, faulty energized or signal-carrying cables, metallic barriers, external monitors
and/or LCD displays, etc.
‒ Do not cover neither the DPA06 device nor the Bluetooth adapter at the PC.
‒ Avoid the simultaneous use of several DPA06 devices via Bluetooth right next to each other.
EN 6008.758.104e - 2015-12
Description
43