Checking Dpa, Pc Drivers, Com, Usb, And Bluetooth Interface - ZF 6008.208.450 Betriebsanleitung

Description

2.4.7 Checking DPA, PC drivers, COM, USB, and Bluetooth interface

Install USB driver for DPA device
The respective driver for DPA05 and DPA06 is automatically set up with the ZF-Testman installation.
At initial startup of DPA via USB, Windows indicates a new hardware which is then automatically installed (requirement:
connecting PC and DPA via USB cable, DPA supplied with 12/24 V operating voltage). With newer operating systems like e.g.
Windows 7, the DPA can then be used.
With older systems, like e.g. Windows XP, the installation wizard "InstallShield Wizard" opens automatically. Follow the instruc-
tions of the software and select the "Search and install automatically" option. Then the DPA can be used. If the installation wizard
"InstallShield Wizard" is canceled, the installation can later only be performed via the device manager (Start/Settings/System
Control/System/Hardware/Hardware Assistant).
By clicking on the "Connect" button (10, refer to Chapter 2.4.6) you can check whether the driver was installed correctly.
If this is the case, the current firmware version of the connected DPA device is displayed under "DPA" (2, refer to Chapter 2.4.6).
If new firmware is available (is being updated via ZF-WebSync), it can be updated via the "Update DPA" button (12, refer to
Chapter 2.4.6). If the DPA device contains outdated firmware, this is indicated during the communication setup. In addition, the
DPA05 hardware can be re-programmed on demand.
Re-programming DPA05 hardware image:
1. Connect the DPA05 to the COM interface of your PC.
2. Supply the DPA05 with 12/24 V operating voltage.
3. Select "COM" as connection type (4, refer to Chapter 2.4.6).
4. Click on the "Load DPA05" button.
41
EN 6008.758.104e - 2015-12