Connections; Recommended Amplifier; Pre-Amplifying Mixers; Placement - Ecler UMA Serie Bedienungsanleitung

5. CONNECTIONS

good quality, have sufficient conductor area and be as short as possible. The latter fact is specially
important when the distance is long and the load impedance low (4-8 Ω). A cross-section of at least
2
2.5mm is recommended for distances up to 10m; 4 or 6mm
gives the required section, assuming 4% losses:
diagram. The back panel connexion plate has a second Speakon® connector to connect
loudspeakers in parallel. With this manual you'll find a spare Speakon® connector.

6. RECOMMENDED AMPLIFIER

UMA112 between 350 and 700W
UMA115 between 450 and 900W
UMA215 between 1000 and 2000W
UMA SB118 between 500 and 1000W

7. PRE-AMPLIFYING MIXERS

8. PLACEMENT

prove more effective if placed on the floor horizontally, instead of flying, elevating or placing the unit
vertically. No obstacles should stand between the enclosures and the audience. The high
frequencies are very directive compared to the low frequencies, so that any obstacle will impair their
response. In case large audiences must be addressed, a better long distance sound propagation will
be achieved if the enclosures are flown high enough.
6
Downloaded from www.Manualslib.com
The connection cables which connect the amplifiers output and the speaker should be of
2
Cross section in mm
Always respect polarity. All connections are Speakon® type. The pin-out is indicated in the
Following table shows the output power of the amplifier adequate to each acoustic system:
Avoid excessive gain adjustments in the equalizer or tone control sections.
Consider following general rules:
Place the acoustic enclosures on solid and firm surfaces. The Sub bass speakers will
manuals search engine
2
for longer distances. Following formula
Length in m
⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯
=
Loudspeaker Impedance in Ω