Connections - Ecler IC Serie Bedienungsanleitung

IC6
•
•
•
•
•
•
•
•
•
IC8
•
•
•
•
•
•
•
•
•
Note: If you use the speaker for false ceiling in 70V installations, the power for the 100V position will
be half the amount shown on the switch. When used in 50V installations, it will be a fourth of the
amount.
included in the package. Be careful not to damage the speaker when removing the grill.

4. CONNECTIONS

model are clamps for stripped wires. Once
they are connected, all you have to do is
choose the unit's power and mode of
operation
Always pay attention to the polarity.
connected to a low-impedance amplifier, the speaker will not be damaged, but will perform
way below its full potential. If the speaker is accidentally connected to a 100V line in the 8Ω
position, it will be severely damaged.
on how to install the units, please see section 5 of this manual.
Downloaded from www.Manualslib.com
2 way speaker for false ceilings
6.5" polypropylene woofer
25mm tweeter
Power: 40W RMS@8Ω
Sensitivity (1W/1m): 90 dB SPL
Built-in 100V transformer. Power selector: 2.5/5/7.5/15W
External diameter: 204mm
Cut out diameter: 180mm
Installation system: Three revolving fasteners
2 way speaker for false ceilings
8" polypropylene woofer
25mm tweeter
Power: 60W RMS@8Ω
Sensitivity (1W/1m): 91 dB SPL
Built-in 100V transformer. Power selector: 5/7.5/15/30W
External diameter: 245mm
Cut out diameter: 222mm
Installation system: Three revolving fasteners
Each model in the series comes with a protective grill that can be removed with a hook
The connection terminals for each
using a simple screwdriver.
The IC series are shipped from factory with the switch in 100V position. If it is
Use the three revolving fasteners included to easily install the units. For more information
manuals search engine
5