Required Installation Tools; Installing The Bench Mount Kit; Suitable Workplace - HallermannTyton AT2000 CPK Betriebsanleitung

5 .1 Required installation tools

f Perform the necessary installation work with the
following installation tools:
• Open-end spanner (size 13)
• Allen key (size 4)

5 .2 Installing the bench mount kit

The base plate of the bench mount has additional holes
that enable two different installation options.
Normal installation A :
The waste is disposed of through the opening in the base
plate. The base surface must also have a suitable opening.
Optional installation B :
The waste is disposed of in front of the base plate. An
opening in the base surface is therefore not necessary.
11
10
9
8
7
6 5 4
Installing the AT2000 CPK bench mount kit
1 Cap nut
2 Washer
3 Fixing screws (guide roller with bracket)
4 Base plate
5 Fixing screws (column)
6 Fixing screws (tool bracket)
7 Tool mount
8 Column
9 Reel retainer incl. clamp ring
10 Guide roller with bracket
11 Reel brake
A Normal installation (waste disposal through the opening in the base plate)
B Optional installation (waste disposal in front of the base plate)
Operating Instructions • Bench Mount Kit AT2000 CPK • 03/2020 • 106-29020
1 A
2
3
7 8
B
6 5 4
Installation and initial operation
1 Install the column
.
8
f Put the column on the base plate
8
f Insert the three fixing screws
plate into the column
4
f For the optional installation
the front of the base plate
2 Install the tool bracket
f Put the tool bracket
7
f Insert the three fixing screws
plate into the tool mount
4
f For the optional installation
bracket to the front of the base plate
7
it on with two fixing screws
3 Install the reel retainer incl. clamp ring
f Insert the reel retainer incl. clamp ring
hole in the column .
8
f Put the washer and the cap nut
2
the reel retainer and tighten by hand.
9
4 Install the guide roller with bracket
f Insert the guide roller with bracket
opening in the column
f Insert the two fixing screws
into the column and tighten by hand.
8
The reel brake 11 is adjusted at the factory.
It is not necessary to readjust the reel brake.
; The AT2000 CPK bench mount kit is installed.

5 .3 Suitable workplace

To ensure flawless operation of the bench mount, the
workplace must be prepared and arranged as follows:
f The workplace must have sufficient lighting.
f The workplace must have a stable base surface
(e.g. a work table, a workbench or a work surface).
f The base surface must have enough space for the
bench mount and the required work with the bench
mount.
f The base surface must have a suitable opening for
waste disposal (only for installation
.
4
through the base
5
and tighten by hand.
8
, move the column
B
and screw it on.
4
.
7
on the base plate .
4
through the base
6
and tighten by hand.
7
, move the tool
B
and screw
4
.
6
.
9
through the
9
on the thread of
1
.
10
into the
10
.
8
through the bracket
3
).
A
to
8
10
8