Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2 .5 Intended use
The
may only be operated in faultless and
bench mount
safe condition, while keeping safety and potential
dangers in mind.
The
with integrated tool is suitable and
bench mount
intended for the following applications:
•
Automatic tying up the cable bundle up to
max. 20 mm diameter
•
For indoor use only
•
Industrial use
2 .6 Misuse
Any use that is not mentioned in the "Intended use"
section is considered as misuse. The operator of the
bench mount bears sole liability for any resulting damage.
In addition to that, the safety regulations of the tool
also apply
à Operating instructions for Autotool 2000 CPK
In particular, the following use is not permitted:
•
Use with defective parts
•
Use in explosive or inflammable environments
•
Outdoor use
•
Use with high humidity and / or direct solar radiation
•
Manual interventions while the process is running
•
Unauthorised changes and modifications on the
bench mount or the tool and their components
without approval by HellermannTyton
•
Use of spare parts and accessories that were not
tested and approved by HellermannTyton
•
Installation on an unsuitable base.
2 .7 Operator obligations
The operator must:
•
observe and comply with the respectively applicable
national accident prevention regulations and health
and safety regulations.
•
provide the qualified personnel with the required
protective equipment and check, maintain and replace
damaged parts according to the regulations.
2 .8 Personnel qualification
Underage persons of trainees may only perform work
under the supervision of an experienced qualified
personnel and with the express consent of the operator.
Operating Instructions • Bench Mount Kit AT2000 CPK • 03/2020 • 106-29020
2 .8 .1 Qualified personnel for operation
The qualified personnel for advanced operation are
assigned with the following tasks and responsibilities:
•
Operating the tool and the bench mount
•
Elimination of faults or initiation of measures to
eliminate faults
•
Cleaning the tool and the bench mount
Due to their specialised training or practical experience,
this personnel ensures proper handling.
2 .8 .2 Qualified personnel for servicing and
maintenance
Servicing and maintenance may only be performed by
qualified personnel. Due to their specialised training, this
personnel has sufficient knowledge about the tool or the
bench mount and can assess its safe working condition.
Moreover, the personnel is familiar with the following
rules and regulations:
•
Relevant national health and safety regulations
•
Accident prevention regulations
•
Generally recognised rules of the technology,
provisions and standards
2 .8 .3 Trained electrician
Work on the electrical supply and on live components
may only be performed by a trained electrician.
2 .8 .4 Authorised qualified personnel for repairs
and inspection
Repairs and safety inspections may only be performed by
a service technician from HellermannTyton or a service
technician authorised by HellermannTyton.
Safety instructions
6
Werbung
Kapitel
Inhaltsverzeichnis
Fehlerbehebung
