Safety Instructions; Representation And Layout Of Warning Instructions; Classification Of The Warning; Instructions - HallermannTyton AT2000 CPK Betriebsanleitung

2 Safety instructions

The bench mount has been manufactured according to
the current state of technology and recognised safety
regulations. Nonetheless, use of the device can result in
hazards to life and limb for the user or third persons, or in
damage to the bench mount and other material property.
These operating instructions contain information
on safety.
f Always follow all of the instructions to prevent
personal injury, material damage, or environmental
damage.
2 .1 Representation and layout of warning

instructions

The warning instructions relate to actions and are
structured as follows:
SIGNAL WORD
Type and source of danger!
Explanations on the type and source of danger.
f Measures to prevent danger.
2 .2 Classification of the warning instructions
Warning instructions in the operating instructions warn
the user about risks involved with handling the bench
mount and the tool and also provide information on how
to avoid them.
Non-observance can result in accidents with fatalities,
injuries or material damage.
The warning instructions are graded according to the
severity of their danger. In the following, the danger
grading is explained with the corresponding signal words
and warning symbols.
DANGER
Immediate risk of lethal or serious injuries.
WARNING
Possible risk of lethal or serious injuries.
CAUTION
Possible slight injuries.
NOTE
Possible damage to the bench mount, the tool, the cable
bundle, or the surroundings.
Operating Instructions • Bench Mount Kit AT2000 CPK • 03/2020 • 106-29020

2 .3 General safety instructions for power tools

The safety instructions in the operating instructions for
the Autotool 2000 CPK also apply for operating the
Autotool 2000 CPK after installation in the
AT2000 CPK bench mount kit.
WARNING
Risk of severe injury due to failure to observe the
applicable safety instructions!
Failure to observe the safety instructions in these
operating instructions and/or in the other applicable
documents can result in severe injuries, burns, and
electrical shocks.
f Observe all safety instructions and their measures to
prevent danger.
f Observe the operating instructions for the
Autotool 2000 CPK.
f Before performing installation work, cleaning, and
maintenance, switch off the tool and the power
supply unit.

2 .4 Basic safety instructions

2 .4 .1 Cleanliness at the workplace

Tidiness, good lighting and cleanliness at the workplace
make work easier and minimise the dangers and
risks of injury.
Observe the following basic principles for tidiness and
cleanliness at the workplace:
f Put away any tools that are no longer required.
f Avoid tripping hazards (e.g. dispose of rubbish in the
intended containers immediately).
f Clean up soiling caused by grease, oils and other
liquids immediately.

2 .4 .2 Spare parts and accessories

Only genuine spare parts and accessories guarantee correct
function and minimise hazards and risk of injury.
Observe the following basic principles regarding spare
parts and accessories:
f Only use genuine spare parts.
f Check replaced components for proper function.
f Only use accessories that are approved by
HellermannTyton.
Safety instructions
5