Maintenance; Important Information; General Maintenance Measures; Repair - HallermannTyton AT2000 CPK Betriebsanleitung

8 .2 Maintenance

8 .2 .1 Important information

The bench mount must be regularly maintained to ensure
it is working safely.

8 .2 .2 General maintenance measures

The maintenance required for the tool and the power
supply unit is described in the tool's operating
instructions.
à Operating instructions of the AT2000 CPK,
Maintenance section
f Check the bench mount regularly to make sure it is
working properly.
f Check the suitability of the workplace.
f Check the fastened electrical cords for damage.
f Damaged electrical cords must be replaced
immediately by qualified maintenance personnel.

8 .3 Repair

WARNING
Severe injuries due to improperly performed
maintenance work!
Maintenance work not carried out correctly can affect the
safety of the bench mount and result in severe injuries.
f Maintenance work should only be performed by
authorised and trained personnel.
NOTE
Material damage due to improperly performed
maintenance work!
Maintenance work not carried out correctly can damage
the bench mount and result in a malfunction.
f Maintenance work should only be performed by
authorised and trained personnel.

9 Taking out of operation

DANGER
Danger of lethal electric shock!
There is a risk of lethal injury when touching live
components.
f Switch off the power supply unit before taking
out of operation
f Pull the power cable out of the socket.
Taking out of operation is used to decommission the
bench mount.
Operating Instructions • Bench Mount Kit AT2000 CPK • 03/2020 • 106-29020

9 .1 Taking the bench mount kit out of operation

1 Disconnect the power supply unit.
2 Remove the cabling.
3 Remove the tool from the tool bracket.
4 Remove the cable tie reel.
5 Remove the bench mount from the base surface.
6 Label the bench mount with a suitable sign
("out of operation").
7 Dispose of or store the bench mount properly.
à „Disposal" on page 12
; The bench mount is taken out of operation.
9 .2 Putting the bench mount kit back into
operation
1 Check the bench mount for completeness.
2 Check the bench mount works properly.
3 Remove the "out of operation" sign.
4 Install the bench mount at a suitable workplace.
à „Installing the bench mount kit at the workplace"
on page 9
5 Insert the tool.
à „Using the tool" on page 9
6 Connect the tool.
à „Connecting the tool" on page 10
7 Insert the cable tie reel.
à „Inserting the cable tie reel" on page 10
; The bench mount is put back into operation.

10 Disposal

The operator is obliged to properly dispose of the
delivered bench mount and components when they are
no longer used. Disposal of the bench mount, individual
components, as well as operating and auxiliary materials
are sometimes subject to legal regulations.
The responsible local authorities can provide
precise information.
f Dispose of the packaging in compliance with the
applicable disposal and environmental regulations.
f Materials, production waste and operating materials
may only be delivered to authorised collection points.
f In case of uncertainty regarding disposal, contact the
manufacturer.
Taking out of operation
12