Maintenance - Geberit MAPRESS Bedienungsanleitung

EN
If a press connection has not been completely pressed – in
the event of a power cut, for example – it must be pressed
again. The Geberit pressing jaw and the pressing collar
must not be removed or rotated during the process.
Corrective pressing is performed in the same way as a
normal pressing operation. Depending on the state of the
preliminary pressing, there may be considerable idle stroke
before the pressing tool engages during corrective pressing.

Maintenance

Maintenance regulations for Geberit pressing
attachments
For safety reasons, it is absolutely essential to observe the
following maintenance intervals and perform the maintenance work
described. The same also applies to the mandatory maintenance
regulations for the pressing tools. These Geberit pressing collars do
not need to be tested by authorised repair shops if they are used as
intended. Pressing collars and adapter jaws must still be
maintained. Geberit pressing collars and adapter jaws that are not
maintained, or are not professionally maintained, can cause
accidents and injuries.
It is essential to observe the maintenance intervals and
maintenance work outlined below:
40
9007202280124939-1 © 10-2018
968.070.00.0 (01)