Port Settings; Tabelle 75: Cli "Port Settings" Configuration - WAGO 852-1816 Handbuch

176 Anhang
10.2.2.7

Port Settings

Tabelle 75: CLI "Port Settings" Configuration

Node
enable
configure
interface
interface
interface
interface
interface
interface
interface
configure
if-range
if-range
if-range
if-range
if-range
Example
L2SWITCH#configure terminal
L2SWITCH(config)#interface fa1/0/1
L2SWITCH(config-if)#speed auto
Handbuch
Version 1.0.0
Command
show interface IFNAME
interface IFNAME
Show
flowcontrol (off | on)
speed (auto|10-full | 10-
full-n | 10-half | 10-half-n |
100-full | 100-full -n | 100-
half | 100-half-n | 1000-full
| 1000-full-n)
shutdown
no shutdown
description STRINGs
no description
interface range
gigabitethernet1/0/PORTLI
STS
description STRINGs
no description
shutdown
no shutdown
speed (auto|10-full | 10-
full-n | 10-half | 10-half-n |
100-full | 100-full -n | 100-
half | 100-half-n | 1000-full
| 1000-full-n)
Industrial-Managed-Switches
852-1816 Lean-Managed.Switch
Description
This command displays the current port
configurations.
This command is used to enter the "interface
configure node."
This command displays the current port
configurations.
This command disables/enables "Flow Control" for a
port.
This command configures the speed and duplex
mode for a port.
This command disables a specific port.
This command enables a specific port.
This command configures a description for the
respective port.
This command is used to configure the standard
description of the port.
This command is used to enter the interface
configure node.
This command configures a description for the
specific port.
This command is used to configure the standard port
description for the individual ports.
This command disables specific ports.
This command enables specific ports.
This command configures the speed and duplex for
the port.