Werbung
Industrial-Managed-Switches
852-1816 Lean-Managed.Switch
10.2.2.5
MAC Management
Tabelle 73: CLI "MAC Management" Configuration
Node
enable
enable
enable
enable
configure
configure
configure
configure
Example
L2SWITCH(config)#mac-address-table static 00:11:22:33:44:55 vlan 1 port 1
10.2.2.6
Port Mirroring
Tabelle 74: CLI "Port Mirroring" Configuration
Node
enable
configure
configure
configure
configure
Example
L2SWITCH#configure terminal
L2SWITCH(config)#mirror enable
L2SWITCH(config)#mirror destination port 2
L2SWITCH(config)#mirror source ports 3-11 mode both
Command
show mac-address-table
aging-time
show mac-address-table
(static|dynamic)
show mac-address-table
mac MACADDR
show mac-address-table
port PORT_ID
mac-address-table static
MACADDR vlan VLANID
port PORT_ID
no mac-address-table
static MACADDR vlan
VLANID
mac-address-table aging-
time VALUE
clear mac address-table
dynamic
Command
show mirror
mirror (disable|enable)
mirror destination port
PORT_ID
mirror source ports
PORT_LIST mode
(both|ingress|egress)
no mirror source ports
PORT_LIST
Description
This command displays the current "Age Time" for
the MAC address table.
This command displays the current static/dynamic
unicast address entries.
This command displays information on a specific
MAC address table.
This command displays the current unicast address
entries recognized by the specific port.
This command configures a static unicast entry.
This command deletes a static unicast entry from the
address table.
This command configures the MAC table "Age Time."
This command deletes the dynamic address entries.
Description
This command displays the current "Port Mirroring"
configurations.
This command disables/enables "Port Mirroring" on
the switch.
This command specifies the monitor port for the "Port
Mirroring."
This command adds a port or port range as the
source port(s) for the "Port Mirroring."
This command removes a port or port range as the
source port(s) for the "Port Mirroring."
Anhang 175
Handbuch
Version 1.0.0
Werbung
Kapitel
