Before Use; Charging The Battery Pack (See Fig. A); Attaching/Disconnecting The Battery Pack To/From The Appliance; Checking The Battery Charge Level - Parkside Performance PKHAP 20-Li A1 Originalbetriebsanleitung

Before use

Charging the battery pack
(see fig. A)
CAUTION!
► Always unplug the appliance before you
remove the battery pack
it to the charger.
■ Never charge the battery pack
ambient temperature is below 10°C or above
40°C.
♦ Connect the battery pack
battery charger
♦ Insert the power plug into the socket. The
control LED lights up red to indicate that the
appliance is charging.
♦ The green LED indicates that the charging
process is complete and the battery pack
ready.
♦ Push the battery pack
Attaching/disconnecting the battery
pack to/from the appliance
Attaching the battery pack
♦ Push the rotation direction switch
middle position (lock).
Allow the battery pack
handle.
Removing the battery pack
♦ Press the release button
battery pack .
PKHAP 20-Li A1
from or connect
when the
to the high-speed
(see fig. A).
into the appliance.
into the
to click into the
and remove the

Checking the battery charge level

♦ Press the battery charge level button
check the charge level of the battery.
The status/remaining charge will be shown on
the battery display LED
RED/ORANGE/GREEN = maximum charge/
performance
RED/ORANGE = medium charge/performance
RED = low charge – charge the battery

Use

Additional handle

NOTE
► For safety reasons, you should never use this
appliance without the additional handle
attached.
♦ Remove the additional handle
is
a clockwise direction (see fold-out page).
♦ Turn the additional handle
position.
♦ Fix the additional handle
by turning it anticlockwise.

Depth stop

♦ Push the locking button for the depth stop
and keep it pushed in.
♦ Insert the depth stop
handle .
♦ Ensure that the toothing on the depth stop
facing downwards.
♦ Pull the depth stop
between the tip of the drill and the tip of the
depth stop corresponds with the required
drilling depth.
♦ Release the locking button for the depth stop
to lock the depth stop.
to
as follows:
by turning it in
to the desired
in the new position
into the additional
out until the distance
GB │ CY
│
7
is
■