Installation - Santec VTC-279IRPWD Bedienungsanleitung

Included items
1 x camera (VTC-279IRPWD, VTC-280IRPWDU, VTC-282IRPWD or VTC-289IRPWD)
1 x cable adapter BNC socket/plug
1 x Allen wrench
1 x user manual

3. Installation

This camera is a compact camera in a weather-proof housing, class IP-66. It comes with a
wall bracket and integrated cable management. You will find the technical data on the
following pages.
1. Bracket and camera installation
Make sure to fix the camera onto a solid basis which is capable to carry the weight of the
camera. Ensure that the camera is safely installed by using only suitable screws.
2. Power supply and monitor impedance
Only use a stabilised 12V DC or 24 V AC power supply unit with sufficient wattage (see
chapter "Specifications" for recommended power supply). Only approved cables should be
used.
If a monitor is connected directly, the monitor impedance has to be set to 75 Ohm. Verify the
position of the switch in case the video picture is of poor quality.
Power supply is being connected to the red cable plug (mid pin +, outside -).
The yellow BNC plug is for the video output.
A cable adapter BNC socket/plug is included in the delivery which can be put onto the
additional video output, e.g. to connect a monitor during the camera installation phase in
case the regular cable has already been laid (picture 2).
Camera VTC-280IRPWDU is equipped with a RJ-45 system connector (see below).
3. Special feature for camera VTC-280IRPWDU
Camera VTC-280IRPWDU is equipped with a RJ-45 system connector. Hence the following
is possible: remote power supply, OSD parameterising via RS-485 and UTP (twisted pair) of
the video signal.
RJ-45 system connector: Pins (front view of RJ-45 jack):
8
4. Camera housing
The camera housing must not be opened! All camera adjustments and connections are
accessible from the outside.
Improper handling of the appliance will invalidate the warranty.
_________________________________________________________________________________
Bedienungsanleitung / User Manual VTC-279IRPWD / VTC-280IRPWDU
7 6 5 4 3 2 1
Pin:
1 Video UTP
2 Video UTP
3 RS-485 +
power supply – or ~
4
5 power supply + or ~
6 RS-485 -
7 -/-
8 -/-
- 24 -
VTC-282IRPWD / VTC-289IRPWD