Troubleshooting - Schwamborn OES 430 Originalbetriebsanleitung

EN OES 430
Translation of the original operating instructions

6 Troubleshooting

Always secure the machine according to
regulations during lifting or transport by a vehicle
or suitable devices and strap down with tension
belts.
For longer periods in transport or in storage, the
"
machine needs to be covered to protect it
against soiling.
6 Troubleshooting
Only suitably knowledgeable, qualified professional technicians may perform repairs on the machine.
Fault
The machine does not
start.
The grinding pattern is un­
even.
The machine shuts down
independently.
Cause
The voltage supply has not been prop­
erly connected.
The connecting cable is defective.
Faulty mains connection.
A safety switch is defective.
The tool is loose.
The pad, brush, or the grinding wheel
is damaged or worn.
The machine is overloaded.
The drive overload protection has trig­
gered.
The extension cable's cross section is
too small.
Remedy
Connect the connecting cable (exten­
sion cable) with a proper power socket.
Replace the connecting cable.
Use a different power socket if neces­
sary.
Replace the safety switch.
Fasten the tool.
(! Chapter 4.2, page 19).
Replace the pad, brush, or the grinding
wheel.
(! Chapter 4.2, page 19).
— Reset:
a. Wait 2 ... 3 minutes.
b. Restart the machine
(! Chapter 3.1).
— If the drive overload protection
trips repeatedly, the load on the
machine needs to be reduced
(mount other tools if necessary),
otherwise motor damage could re­
sult!
Check the extension cable and replace
if necessary.
21