Important Information; Customer Service And Spare Parts; Liability And Warranty; Used Symbols And Designations - Schwamborn OES 430 Originalbetriebsanleitung

EN OES 430
Translation of the original operating instructions

1 Important information

1 Important information
The machine may only be used with task-specific
accessories supplied by the manufacturer for:
— Cleaning
— Polishing
— Wet and dry grinding
— Crystallizing
— Stripping
of even, level floor surfaces such as
— Tiling
— Vitrified clay
— Natural stone
— Screed
— Parquet floor
— Linoleum
— Plastic
Any other use of the machine can lead to dangerous
situations and is prohibited!
To ensure the intended use of the machine, follow
the instructions in the operating manual, paying
particular attention to any warning notices and
instructions relating to operation and maintenance!
Before using the machine, the
operating personnel must carefully
read and understand this operating
manual!
The operating manual must always be
kept close at hand.
Read and observe documents and operating manuals
provided by suppliers if available.
If the machine is on loan to other parties, the
operating manual needs to be provided with the
machine and its importance must be made clear!
The Illustrations show some machines with
optional equipment.

1.1 Customer service and spare parts

In case of customer service queries, accessories,
spare parts or repairs, please contact the manufactu‐
rer. To ensure your queries are dealt with as quickly
as possible, always include the specific data of your
machine. These are located on the machine's type
plate.
14

1.2 Liability and warranty

 Schwamborn Gerätebau GmbH
All rights, including those pertaining to translation, lie
with Schwamborn Gerätebau GmbH.
No part of this documentation may be reproduced,
used or distributed in any form without the written
permission of Schwamborn Gerätebau GmbH.
Liability or warranty is excluded if:
— The instructions in the operating manual have
not been observed.
— The machine or its attachments were improperly
operated.
— The maintenance was carried out inadequately
or incorrectly.
— Spare parts other than those prescribed were
used.
— The protective equipment was not used, has
been altered or was removed.
— The specified power supply ratings and
surrounding conditions have not been observed.
The manufacturer is not liable for any damage that
may result if the user makes any changes to the
machine without the manufacturer's permission. Any
such actions will void the warranty.

1.3 Used symbols and designations

The following symbols are used in this
documentation:
Safety instructions
This symbol indicates warnings, prohibitions and
instructions regarding potential hazards. These
instructions must be obeyed and closely
observed.
Some safety instructions are accompanied by
corresponding symbols.
Warning Interdiction
Additional note
This symbol indicates additional information.
The oscillating single-disc machine is referred to
"
as the machine in this operating manual.
Pads, brushes and grinding wheels are referred
"
to in this operating manual as tools.
Instruction